LED controller for single colour LED strips WS2811 5-24Vdc, with external switch contacts, Number of control points: up to 2048 pixels (2048 IC)

Basic parameters:

Operating voltage: 5-24 V

Number of control points: up to 2048 pixels (2048 IC)

3. Exposure: 15 types, water flows forward when the machine is switched on and water flows backwards when the machine is switched off.

4. It can be equipped with multiple switches for linkage control, and can learn to encode group control. Several controllers can use the switches in the same place without interfering with each other.

User manual:

1. Pixel count selection (led strip length ) (ON/OFF contact is disconnected (open )!) during setup:

1.1. Enter pixel setting mode - press and hold down1. button for at least 3 seconds.

1.1.1. Increasing the number of pixels - click on the button 1 to increase the number of pixels by +1 pixel. Repeat this operation until you have set the desired number of pixels.

(If you want to increase the pixel count faster, press and hold the button1).

1.1.2. Decreasing the number of pixels - click the button 2 to decrease the number of pixels by -1 pixel. Repeat this operation until you have set the desired number of pixels.

(If you want to reduce the pixel count faster, click and hold the button2).

1.1.3. Checking the effect - press and hold button3 to check the current effect with the new pixel number.

2. Selecting the light effect (during setup connected to the (short) on/off contact!):

2.1. Light effect selection - click button1, to select the next light effect. Repeat this step until you have set the desired light effect.

2.2. Checking the light effect - open and close the on/off contact to check the new light effect.

3. Selecting the brightness (the ON/OFF contact is disconnected (open ) during setting!)

3.1. Brightness selection - click the button2. Repeat this operation until the desired brightness level is set. (Once the maximum brightness is set and the button is clicked again2, the brightness will return to the minimum level).

3.2. Quickly set maximum brightness - Press and hold button 2 for at least 3 seconds.

3.3. Brightness check - Press and hold the button3 to check the new brightness level with the current lighting effect.

4. Light effect speed selection( connected to (short) on/off contact during setting!):

4.1. Speed Selection - press the button 2. Repeat this step until you have set the desired speed of the light effect.After each click you will see more pixels light up indicating the speed you have selected. (When the maximum speed is set and the button 2 is pressed again, the speed returns to the lowest level).

4.2 Quick maximum speed selection - Press and hold the 2ndbutton for at least 3 seconds until the maximum speed indication lights up on the ice bar.

5. Pixel length selection (10 cm or 3 cm) +R/G/B signal sequence change ( ON/OFF contact(short) connected during setup!):

5.1. Pixel length setting mode - Press and hold button 1 for at least 3 seconds.

5.1.1. Changing the pixel length/RGB signal sequence - click the button 2. Repeat this operation until the desired pixel configuration is set. After each click, you will see an indication on the LED bar which mode has been selected.

5.1.2 Testing settings + saving settings - click button 1, to exit pixel length setting mode and test new pixel settings with the existing effect.